Laser

Photo to laser engraving

The laser engrave preset is selected. A photo becomes a few flat tones, which can be filled or scored. It does not become a dithered photograph.

Image converter

Drop a PNG, JPG, or WebP

You can also paste an image, or pick a file.

Nothing is uploaded. The picture stays on this device. There is no account, and the SVG you download is not watermarked.

Maker preset

A few flat tones for engrave regions. This is not a photo halftone, and it does not set power or speed.

Drops islands smaller than this many pixels on a side. 0 keeps every speck.

Clears the color that dominates the edge, including a near-white edge. Spots of that color inside the design are cleared too.

Stacked sheets offsets each layer in the preview only. The download stays assembled, in paint order.

Your layered preview shows up here. Hide a layer to leave it out of the download.

Height follows the picture. SVG, DXF, and PDF use this width.

SVG keeps the curves and sets its width and height from the finished size. DXF polylines use that same width in millimetres, with curves flattened and Y flipped upright. PDF is one page at that size. The zip is one SVG per visible layer. Design Space, LightBurn, and xTool usually honor the size. If one ignores it, set the width again there.

A Pro plan is planned for people who want unlimited layered files. It is not for sale, and there is no price yet. What that means

Poster regions, then your laser settings

Laser software can burn a photo by scanning it like a printer. This site does not do that scan. It quantizes the photo and traces the edges, the same as the SVG for laser engraving guide. Use that when you want a logo. Use this page when the source is a photo and you still want vectors, knowing the face will simplify.

Set the part width in inches or millimetres before export. DXF polylines are in millimetres at that width, with curves flattened. SVG keeps the curves. Neither file contains power, speed, or a real kerf offset. The cut check uses about 0.2 mm only as a speck threshold at your width.

The picture stays on this device. There is no account and no watermark. If the trace is too busy, Remove specks or lower the color count, then look again. High anchor counts get a warning. That warning is a point count, not minutes from your machine. More shop notes are on the laser overview and the converter.

Questions

Will this engrave the photo as a photo?

No. You get a few flat regions. A portrait will not survive as a portrait. Use the image or grayscale mode in your laser software for a photographic burn.

What does the 0.2 mm check mean?

At the width you set, pieces smaller than about 0.2 mm are flagged. That is near a typical kerf, so a speck that small is not a useful engrave feature. It is not a measured kerf for your tube.

Does the file include power or speed?

No. Set those in LightBurn, xTool, or Glowforge. This page only makes the shapes and the size.